Geberit G243173001 Water Supply Hose

Introduzione

This manual provides essential instructions for the safe and correct installation, operation, and maintenance of the Geberit G243173001 Water Supply Hose. This hose is specifically designed to connect the water supply to the Geberit Duofix Carrier 111.798, which is used with bidet seats. Please read this manual thoroughly before installation and keep it for future reference.

Informazioni sulla sicurezza

• Always shut off the main water supply before beginning any plumbing work.
• Ensure all connections are hand-tightened first, then gently tightened with a wrench to prevent leaks without overtightening.
• Inspect the hose and connections regularly for any signs of wear, damage, or leaks.
• In caso di dubbi su qualche passaggio, consultare un idraulico qualificato.

Contenuto della confezione

The Geberit G243173001 package includes:

• 1 x Geberit G243173001 Water Supply Hose

No additional tools or components are included with this product.

Specifiche

Configurazione e installazione

Before you begin, ensure the main water supply to the toilet area is turned off. You may need a wrench for tightening connections.

1. Preparare l'area: Turn off the main water supply valve. Flush the toilet to drain the tank and bowl.
2. Identificare i punti di connessione: The Geberit G243173001 hose has two distinct ends. One end connects to the water supply valve, and the other connects to the Geberit Duofix Carrier 111.798.
3. Collegamento alla rete idrica: Carefully attach one end of the hose to the water supply valve. Hand-tighten first, then use a wrench for a quarter to half turn until snug. Do not overtighten.


Image: Water supply connection point of the hose.

4. Connect to Duofix Carrier: Attach the other end of the hose to the designated water inlet on the Geberit Duofix Carrier 111.798. Hand-tighten, then use a wrench for a snug fit.


Image: Carrier connection point of the hose.

5. Controllo finale: Assicurarsi che entrambe le connessioni siano sicure.

Immagine: Oltreview of the Geberit G243173001 Water Supply Hose.

Operativo

After installation, slowly turn on the main water supply valve. Check all connections for leaks immediately. If no leaks are present, the system is ready for use with the Geberit Duofix Carrier and connected bidet seat.

Manutenzione

• Periodically inspect the hose and its connections for any signs of wear, cracks, bulges, or corrosion.
• Check for any drips or moisture around the connection points. Address any leaks promptly.
• Replace the hose if any damage is observed to prevent potential water damage.

Risoluzione dei problemi

Perdite nei collegamenti

• Causa: Loose connection or damaged washer/gasket.
• Soluzione: Turn off water supply. Gently tighten the connection with a wrench. If the leak persists, check the washer/gasket inside the connector for proper seating or damage. Replace if necessary.

Nessun flusso d'acqua

• Causa: Water supply valve is off or partially closed.
• Soluzione: Ensure the main water supply valve and any inline shut-off valves are fully open.

Informazioni sulla garanzia

For detailed warranty information regarding the Geberit G243173001 Water Supply Hose, please refer to the official Geberit website or contact Geberit customer service directly. Warranty terms and conditions may vary.

Assistenza clienti

If you have any questions, require technical assistance, or need to order replacement parts, please visit the official Geberit website or contact their customer support department. Contact details can typically be found on the Geberit websito o confezione del prodotto.