FLYLINKTECH CET224

FLYLINKTECH V6 3500 mAh Replacement Battery Instruction Manual

Model: CET224

Introduzione

Thank you for choosing the FLYLINKTECH V6 3500 mAh Replacement Battery. This battery is designed to provide extended power for your Dyson V6 series handheld vacuum cleaner. It features premium Samsung cells and a smart battery protection board for reliable performance. This manual provides essential information for the safe and effective use of your new battery.

Contenuto della confezione:

  • 1 x FLYLINKTECH V6 Replacement Battery (3500 mAh)
  • 2 x V6 Replacement Pre-filters
FLYLINKTECH V6 Replacement Battery and included filters

Image: The FLYLINKTECH V6 replacement battery shown alongside the two included pre-filters.

Configurazione e installazione

Before first use, please ensure the battery is fully charged. Follow these steps to install the replacement battery:

  1. La sicurezza prima di tutto: Ensure your Dyson vacuum cleaner is turned off and unplugged from any charging source.
  2. Individuare la batteria: The battery pack is typically located at the bottom of the vacuum's handle.
  3. Rimuovere la vecchia batteria: Unscrew the retaining screws that secure the old battery in place. Carefully slide out the old battery.
  4. Installa una nuova batteria: Align the FLYLINKTECH replacement battery with the vacuum's battery slot. Slide it into place until it clicks securely.
  5. Batteria sicura: Reinsert and tighten the retaining screws to hold the new battery firmly.
  6. Carica iniziale: Connect your vacuum cleaner to its charger. Allow the battery to fully charge before its first use.
FLYLINKTECH V6 battery being installed into a Dyson V6 vacuum cleaner

Image: A visual representation of the FLYLINKTECH V6 battery being inserted into a compatible Dyson V6 vacuum cleaner.

Dyson V6 vacuum cleaner charging with the FLYLINKTECH battery

Image: A Dyson V6 vacuum cleaner connected to its charging dock, illustrating the charging process for the replacement battery.

Istruzioni per l'uso

The FLYLINKTECH V6 replacement battery operates identically to the original Dyson battery. Simply press the power trigger to start and release to stop. For optimal battery life and performance, consider the following:

  • Modalità standard: For everyday cleaning tasks, using the standard power mode is recommended to maximize operating time.
  • Modalità MAX: The MAX power mode provides increased suction for tougher cleaning but will significantly shorten the battery's run time. Use this mode only when necessary.
  • Ricarica: Always ensure the battery is fully charged before extensive use.
Dyson V6 vacuum cleaner in operation with the FLYLINKTECH battery

Image: A Dyson V6 vacuum cleaner in active use, demonstrating the battery's integration and function during operation.

Manutenzione

Proper maintenance will extend the life of your battery and vacuum cleaner.

  • Raffreddamento della batteria: Do not charge the battery immediately after it has been depleted, especially after using MAX mode. Allow the battery to cool down for 10 to 20 minutes before charging. This is crucial for battery longevity.
  • Pulizia del filtro: The included V6 replacement pre-filters are washable and reusable. Regularly clean the filters according to your vacuum cleaner's instructions to maintain optimal suction and prevent strain on the battery.
  • Magazzinaggio: If storing the vacuum for an extended period, ensure the battery is partially charged (around 50%) and store it in a cool, dry place.
Dyson V6 pre-filter being washed under running water

Image: A Dyson V6 pre-filter being rinsed under running water, illustrating the recommended cleaning process.

Risoluzione dei problemi

If you encounter issues with your FLYLINKTECH V6 replacement battery, refer to the following common solutions:

ProblemaPossibile causaSoluzione
Battery not charging or vacuum not powering on.Battery not properly installed; charger not connected; battery too hot/cold.Ensure battery is securely installed. Check charger connection. Allow battery to cool down (10-20 minutes) if recently used, or warm up if in a cold environment.
Flashing yellow light on battery/vacuum.La batteria è troppo calda o troppo fredda.Do not attempt to charge or use the battery immediately. Allow it to reach room temperature (10-20 minutes) before proceeding.
Tempo di esecuzione ridotto.MAX mode used excessively; dirty filter; battery not fully charged.Use standard mode for daily cleaning. Clean or replace filters regularly. Ensure battery is fully charged before use.

Specifiche del prodotto

  • Marca: TECNOLOGY DI FLYLINK
  • Numero modello: CET224
  • Tipo di batteria: Agli ioni di litio
  • Capacità della batteria: 3500 mAh
  • Voltage: 21.6 Volt
  • Riutilizzabilità: Ricaricabile
  • Uso consigliato: Aspirapolvere
  • Peso dell'articolo: 460 grammi
  • Dimensioni dell'articolo: Dimensioni: 13 x 8.8 x 1 cm
  • Modelli compatibili: Dyson V6 SV03, SV04, SV05, SV06, SV07, SV09, DC58, DC59, DC61, DC62, DC72, DC74 series handheld vacuum cleaners.
Diagram showing internal lithium-ion battery cells and protection board

Image: An internal diagram illustrating the lithium-ion battery cells and the integrated smart protection board within the battery pack.

Garanzia e supporto

FLYLINKTECH provides a 1-year warranty and a 30-day refund policy for this product. We are committed to friendly customer service.

For any questions, concerns, or support needs, please contact us through:

We will endeavor to resolve any issues promptly.

© 2026 FLYLINKTECH. Tutti i diritti riservati.

Documents - FLYLINKTECH – CET224

nessun documento rilevante

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.