Manuale utente del drone da pesca SwellPro FD3

1. Introduzione

This manual provides essential instructions for the safe operation, setup, and maintenance of your SwellPro FD3 Fisherman Waterproof Fishing Drone. The FD3 is designed for marine environments, featuring IP67 waterproofing, a 4K camera, and a dual bait release mechanism for fishing applications. Please read this manual thoroughly before operating the drone to ensure proper use and to prevent damage or injury.

Linee guida di sicurezza

• Utilizzare sempre il drone in aree aperte, lontano da persone, animali e ostacoli.
• Mantenere una distanza di sicurezza dal drone durante il funzionamento.
• Do not operate the drone in strong winds, heavy rain, or lightning.
• Assicurarsi che tutte le batterie siano completamente cariche prima di ogni volo.
• Ispezionare regolarmente il drone prima e dopo l'uso per verificare la presenza di eventuali danni.
• Rispettare tutte le normative e le leggi locali in materia di utilizzo dei droni.

2. Contenuto della confezione

Verify that all items listed below are present in your package. If any items are missing or damaged, please contact SwellPro support.

Figura 2.1: The SwellPro FD3 Fisherman drone shown with its primary accessories, including the remote control, flight battery, charger, and bait release mechanism.

• SwellPro FD3 Fisherman Drone (x1)
• Telecomando (x1)
• Batteria di volo intelligente (x1)
• Caricabatterie (x1)
• Propellers (sets)
• Dual Bait Release Mechanism (x1)
• Manuale dell'utente (questo documento)
• Other accessories (e.g., cables, tools)

3. Impostazione

3.1 Assemblaggio del drone

1. Fissare le eliche: Carefully attach the propellers to the motor shafts. Ensure correct propeller type (CW/CCW) matches the corresponding motor. Tighten securely.
2. Installare la batteria di volo: Insert the intelligent flight battery into the drone's battery compartment until it clicks into place.
3. Attach Bait Release Mechanism: Secure the dual bait release mechanism to the drone's underside according to the provided diagrams. Ensure it is firmly attached and cables are connected.
4. Installa la fotocamera: Mount the 4K camera onto its designated gimbal or mounting point, ensuring all connections are secure.

Figura 3.1: Top-down view of the SwellPro FD3 drone, illustrating the propeller and motor configuration. Ensure propellers are correctly installed for safe flight.

3.2 Ricarica della batteria

Charge both the intelligent flight battery and the remote controller battery before first use and after each flight.

• Collegare il caricabatteria a una presa di corrente.
• Connect the flight battery to the charger. The indicator light will show charging status.
• Connect the remote controller to its charger (usually via USB).
• Charge until all indicator lights show a full charge.

3.3 Configurazione del telecomando

Figura 3.2: The SwellPro FD3 drone positioned next to its remote control, which features a built-in display for real-time flight data and camera feed.

Power on the remote controller. If it does not automatically connect to the drone, follow the binding procedure outlined in the quick start guide or the full manual (if available separately) to establish a connection.

3.4 Installazione dell'app (facoltativa)

For advanced features and real-time telemetry, download the official SwellPro app from your device's app store. Follow the in-app instructions to connect your drone and remote controller.

4. Utilizzo del drone

4.1 Lista di controllo pre-volo

• Assicurarsi che tutte le batterie (del drone e del telecomando) siano completamente cariche.
• Controllare che le eliche non siano danneggiate e assicurarsi che siano fissate saldamente.
• Verify the bait release mechanism and camera are properly installed.
• Check the weather conditions (wind speed, rain).
• Ensure sufficient GPS signal (if operating in GPS mode).
• Clear the flight area of any obstacles, people, or animals.

Figura 4.1: The SwellPro FD3 drone in flight over water, demonstrating its waterproof capabilities. Always perform a pre-flight check before launching.

4.2 Controlli di volo di base

Refer to the remote controller diagram (usually found in the quick start guide) for specific stick and button functions. Common controls include:

• Levetta sinistra: Throttle (up/down), Yaw (rotate left/right)
• Levetta destra: Beccheggio (avanti/indietro), Rollio (sinistra/destra)
• Pulsante Ritorno a casa (RTH): Avvia il ritorno automatico al punto di decollo.
• Bait Release Button: Attiva il meccanismo di rilascio dell'esca.
• Controlli della fotocamera: Buttons for photo capture and video recording.

4.3 Bait Release Operation

1. Securely attach your fishing line with bait to the dual bait release mechanism. Ensure the weight does not exceed the drone's maximum payload capacity (4.4 lbs).
2. Fly the drone to your desired casting location.
3. Once in position, press the dedicated bait release button on the remote controller. The mechanism will open, dropping the bait.
4. Confirm the bait has been released via the camera feed or visual observation.

4.4 4K Camera Operation

• Ensure a compatible microSD card is inserted into the camera.
• Use the dedicated buttons on the remote controller to start/stop video recording or take photos.
• The live video feed will be displayed on the remote controller's screen or connected mobile device.

4.5 Auto Drop & Return

The FD3 features intelligent flight functions:

• Auto Drop: This refers to the automated bait release function, triggered by the remote controller.
• Ritorno a casa (RTH): When activated, the drone will automatically fly back to its recorded takeoff point and land. This feature is also triggered automatically if the battery level is critically low or if the control signal is lost.

5. Manutenzione

5.1 Pulizia

• After use, especially in saltwater environments, rinse the drone thoroughly with fresh water.
• Wipe the drone dry with a soft cloth. Ensure all ports and connectors are free of moisture before charging or storing.
• Pulisci l'obiettivo della fotocamera con un panno in microfibra.

5.2 Conservazione

• Conservare il drone e le batterie in un luogo fresco e asciutto, lontano dalla luce solare diretta e da temperature estreme.
• For long-term storage, discharge batteries to approximately 50-60% capacity.
• Remove propellers if storing in a compact case.

5.3 Cura della batteria

• Non sovraccaricare o scaricare eccessivamente le batterie.
• Se una batteria appare gonfia o danneggiata, interromperne immediatamente l'uso e smaltirla correttamente.
• Avoid puncturing or exposing batteries to extreme heat.

6. Risoluzione Dei Problemi

7. Specifiche

8. Garanzia e supporto

For warranty information, please refer to the warranty card included with your product or visit the official SwellPro website. For technical support, troubleshooting assistance, or spare parts, please contact SwellPro customer service.

SwellPro Official Websito: www.swellpro.com

Negozio Amazon: Visit the SwellPRO Store on Amazon