Introduzione
This manual provides essential instructions for the Generac 0J93230SSM Maintenance Kit, designed to facilitate routine upkeep for Generac 20kW to 22kW generators. Regular maintenance using genuine Generac parts is crucial for ensuring the longevity and reliable performance of your generator. This kit includes all necessary components for a standard service interval.
The kit contains genuine OEM Generac parts, specifically chosen to fit Generac engine models requiring this part number.
Componenti del kit oltreview
The Generac 0J93230SSM Maintenance Kit includes the following items:
- Two (2) Quarts of SAE 5W-30 Full Synthetic Engine Oil
- One (1) Air Filter
- One (1) Oil Filter (Part #: 070185E)
- Two (2) Spark Plugs
- One (1) Service Sticker
Procedure di manutenzione
Regular maintenance is vital for the optimal performance and longevity of your Generac generator. Always refer to your generator's specific owner's manual for detailed safety precautions and procedures.
1. Cambio dell'olio motore
The kit includes two quarts of SAE 5W-30 full synthetic engine oil. This oil is formulated for optimal performance in various temperatures.
- Assicurarsi che il generatore sia spento e raffreddato.
- Locate the oil drain plug and place a suitable container underneath to collect used oil.
- Remove the drain plug and the oil fill cap/dipstick. Allow all old oil to drain completely.
- Richiudere bene il tappo di scarico.
- Carefully pour the new SAE 5W-30 synthetic engine oil into the oil fill opening. Refer to your generator's manual for the exact oil capacity.
- Check the oil level with the dipstick, ensuring it is within the recommended range.
- Riposizionare il tappo di riempimento/astina di livello dell'olio.
2. Oil Filter Replacement
The kit includes one Generac oil filter (Part #: 070185E).
- After draining the old engine oil, locate the oil filter.
- Use an oil filter wrench to loosen and remove the old oil filter. Be prepared for some oil spillage.
- Apply a thin film of new engine oil to the rubber gasket of the new oil filter.
- Screw on the new oil filter by hand until the gasket makes contact with the engine block. Then, tighten an additional 1/2 to 3/4 turn. Do not overtighten.
- After refilling the engine oil, run the generator for a few minutes and check for leaks around the oil filter.
3. Sostituzione del filtro dell'aria
The kit includes one air filter. A clean air filter ensures proper engine breathing and prevents contaminants from entering the engine.
- Locate the air filter housing on your generator.
- Open the housing by releasing le clip o le viti.
- Remove the old air filter. Note its orientation.
- Pulire eventuali detriti dall'interno dell'alloggiamento del filtro dell'aria.
- Insert the new air filter, ensuring it is seated correctly.
- Chiudere e fissare l'alloggiamento del filtro dell'aria.
4. Sostituzione della candela
The kit includes two spark plugs. Replacing spark plugs ensures efficient ignition and optimal engine performance.
- Ensure the generator is off and cooled. Disconnect the spark plug wires.
- Use a spark plug wrench to carefully remove the old spark plugs.
- Inspect the new spark plugs for correct gap (refer to your generator's manual for specifications). Adjust if necessary.
- Avvitare manualmente le nuove candele nella testata del cilindro per evitare che si incastrino male.
- Tighten with a spark plug wrench. Do not overtighten; typically, a quarter to half turn after hand-tight is sufficient.
- Ricollegare saldamente i cavi delle candele.
5. Service Sticker
Use the included service sticker to record the date and hours of this maintenance service. This helps track future maintenance intervals.
Video del prodotto
Specifiche
| Caratteristica | Dettaglio |
|---|---|
| Marca | Generazione |
| Nome del modello | 0J93230SSM |
| Consigliato per | Generac 20kW-22kW Generators |
| Componenti inclusi | 2 Quarts of 5W-30 Synthetic Motor Oil, 1 Air Filter, 1 Oil Filter, 2 Spark Plugs, 1 Service Sticker |
| Peso dell'articolo | 2.76 libbre (circa) |
| Dimensioni del prodotto | 27.94 x 27.94 x 27.94 pollici (dimensioni approssimative della confezione) |
| Materiale | Plastic (for some components) |
| Caratteristica speciale | Maintenance kit, Tune up kit |
Garanzia e supporto
For specific warranty information regarding the Generac 0J93230SSM Maintenance Kit or its individual components, please refer to the documentation included with your purchase or visit the official Generac websito.
For technical support, troubleshooting assistance, or to locate authorized service centers, please contact Generac customer service directly or consult your generator's owner's manual.
