JoJo Booster Pump Flow Controller
Specifiche
- Nome del prodotto: JoJo Booster Pump Flow Controller
- Compatibile con: JoJo Booster Pumps
- Parte di ricambio: JoJo PC Board
- Strumenti necessari: STAR SCREW DRIVER
Richiederai quanto segue:
Nota: Our Booster Pump PC Board is only suited for use with the following JoJo
Booster Pumps:
- Pompa booster da 0.37 kW
- 0.55kW, 0.75kW & 1.1kW
- pompe centrifughe
- Pompa a getto autoadescante da 0.6kW
Istruzioni per l'uso del prodotto
PASSO 1
Ensure that your pump is disconnected from the power source.
PASSO 2
Unscrew the four screws holding the terminal box cover in place.
PASSO 3
Rimuovere il coperchio della morsettiera.
PASSO 4
Disconnect the wires from the terminals and remove from the terminal box.
PASSO 5
Unscrew the two screws holding the PC Board in place.
PASSO 6
Rimuovere la scheda PC.
PASSO 7
Insert the replacement JoJo PC Board.
PASSO 8
Insert and fasten the two securing screws on both sides of the PC Board.
PASSO 9
Secure the wires to the terminals as follows:
- the wires from the pump through the bottom grommet
- the wires from the three-point plug through the top grommet.
Nota: ensure that the correct color sequence is followed as shown below
PASSO 10
Replace the terminal box cover, and fasten the four screws holding it in place.
PASSO 11
Your pump is now ready for use and reconnection to your power supply.
Scan the QR Code to watch the instructional video for visual guidance.
Domande frequenti
Can I use the JoJo Replacement PC Board with other pumps?
Our Booster Pump PC Board is only suited for use with JoJo Booster Pumps.
Documenti / Risorse
 |
JoJo Booster Pump Flow Controller [pdf] Guida utente Booster Pump Flow Controller, Pump Flow Controller, Flow Controller, Controller |